It is really different to use a stand-up forklift compared to a sit-down model. The way you transport and pick up cargo in addition to your movements are really different. If you do not have proper training for utilizing a stand-up model, you could potentially cause harm to yourself or to co-employees. When using a stand-up unit, you should follow the correct safety regulations. There are some basic operating standards that must be met when using a stand-up model.
When beginning, stand up on the lift truck in order to get a feel for the steering knob and the controls. The steering is handled utilizing the knob steering plate instead of a steering wheel. Remember that this particular knob moves very fast, thus, you need to get used to moving it gently in order to be sure not to over steer. The horn is located on the control handle, as is the control for forwards, backwards and the movement of the forks. The floor pedal enables the machinery to move.
Turn the key to start the forklift's engine when you are ready to begin. The forks must be retracted at this stage. When you are moving all-around the floor, the forks should be pointed slightly upwards. Do not drive with extended forks. If you are moving forward, move the control handle forward and step on the pedal to make the lift move forward. If you are backing up, be certain to beep your horn to alert people around you. Look behind you before stepping on the pedal so as to make sure the way is safe and clear. Next, while stepping on the pedal, pull the control handle towards you. Always stay alert and focused and make sure that you are always operating in a safe manner.
When it comes to turning corners, turn your steering knob in the direction you need to go while keeping your hand on the control handle and your foot on the power pedal. When turning right, the steering knob would move in a clockwise direction during forward travel. If you are turning left, your steering knob would go in a counter-clockwise direction.
If you have just utilized sit down units, the stand-up versions could take some getting used to. With some training and taking some time to figure out the machinery, you will be able to efficiently and quickly handle loads in little time.